[. . . ] If the driver does it while driving, it may lead to carelessness and cause an accident. Be sure not to let the monitor be strongly impacted since this may cause a malfunction or fire. Doing so with the engine off will consume battery power and may prevent the engine from starting. When not in use, close the liquid crystal panel and store it into the compartment. [. . . ] The monitor temporarily changes its angle as illustrated on the left, and returns to its previous position in about 17 seconds. Press FLAT button to return to its previous position before its automatic return. You can also adjust the monitor position as illustrated on the left on the monitor menu. The monitor angle may automatically move one step when you change the monitor position to BACK, not to hit its back to the unit. In some cases, the black bars may be shown at the top and bottom sides of the screen. In some cases, the black bars may be shown also at the top and bottom sides of the screen. The middle of pictures is reduced horizontally, and the left and right side of the picture enlarged horizontally. In some cases, the black bars may be shown at the top and bottom sides of the screen. pictures are enlarged on the screen so that no black bars will be shown on the screen. Menu selection goes off if other operations are done or no operation is done for about 5 seconds. Initial level: 0 (center) Control the degree of difference between the lightest and darkest parts of the picture. Initial level: 0 (center) Adjust this if the human skin color is unnatural. Initial level: 0 (center) Adjust the light of the screen when you turn on the headlights. Initial setting: FORTH Light on or off the blue LED when you turn on the monitor. The rear view automatically displayed when you change the gear to the back position. The mirror image of the rear view automatically displayed when you change the gear to the back position. : Selecting "CAMERA" or "CAMERA REV" also makes the picture from AV OUT the rear view when changing the gear to the back position. *4 : When selecting "CAMERA" or "CAMERA REV", the functions below does not work in AV2: · *5 : The picture from AV OUT does not become the mirror image. [. . . ] When a cloth with a cleansing chemical is used, follow the caution points. ­ Do not leave the unit in contact with rubber or vinyl products for long periods of time. ­ Do not use cleansers which have polishing granules because this could damage the cabinet. Clean off dirt by wiping lightly with a soft cloth When the cabinet is very dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral) thinned by water and then go over the same surface with a dry cloth. [. . . ]